DSC neo Power Serie Manual De Referencia página 6

[022] Second Keypad Options
Default Opt. ON
ON 1
Local Clock Display ON
I _ _____I
Local Clock Displays 24-
OFF 2
I _ _____I
hr Time
ON 3 Auto Alarm Scroll ON
I _ _____I
OFF 4
For Future Use
I _ _____I
OFF 5
Power LED Enabled
I _ _____I
Power LED Indicates AC
ON 6
I _ _____I
Present ON
Alarms Displayed While
ON 7
I _ _____I
Armed
Auto-Scroll Open Zones
OFF 8
I _ _____I
ON
[023] Third Keypad Options
Default Opt. ON
Armed LED On in
OFF
1
I _ _____I
Sleep Mode
Keypad Status Shows
ON
2
I _ _____I
Stay Arm
Temperature Display
OFF
7
I _ _____I
Enabled
NOTE: Programming options indicated in
pliant with EN50131-1 and EN50131-3 standards. Section [023]: 1=OFF
[030] LCD Message
I _ __ __I _ __ __ I _ _ ___I _ __ __ I _ _ _ __ I _ _ __ _ I _ _ __ _ I _ __ _ _I _ _ _ _ _ I _ __ _ _ I _ _ _ _ _ I _ _ _ _ _ I _ _ _ _ _ I _ _ _ _ _ I _ _ _ _ _ I _ _ _ _ _ |
I _ __ __I _ __ __ I _ _ ___I _ __ __ I _ _ _ __ I _ _ __ _ I _ _ __ _ I _ __ _ _I _ _ _ _ _ I _ __ _ _ I _ _ _ _ _ I _ _ _ _ _ I _ _ _ _ _ I _ _ _ _ _ I _ _ _ _ _ I _ _ _ _ _ |
[031] Downloaded LCD Message Duration
Default: 000 I_____I_____I_____I (Valid entries are 000-255), 000=Unlimited Mes-
sage Display. This number represents the number of times the downloaded
message must be cleared before it is permanently removed.
OFF
Local Clock Display
OFF
Local Clock Displays
AM/PM
Auto Alarm Scroll
OFF
For Future Use
Power LED Disabled
Power LED Indicates
AC Present OFF
Alarms Not Displayed
While Armed
Auto-Scroll Open
Zones OFF
OFF
Armed LED Off in Sleep
Mode
Keypad Status Shows Stay/
Away Arm
Temperature Display Dis-
abled
GREY are required for systems com-
Press any key to delete message.
[041] Indoor Temperature Zone Assignment
Default: 000
I _ _____I _ _____I _ _____I
[042] Outdoor Temperature Zone Assignment
Default: 000
I _ _____I _ _____I _ _____I
[101]-[228] Door Chime for Zones 1-128
The keypad can be programmed to make up to four different chime
sounds for individual zones. (e.g., for Zone 1, enter Section [101], for
Zone 2 enter Section [102]).
Default: 01
I _ __I _ __I
Option
01 6 beeps
02 Bing-Bing tone
03 Ding-Dong tone
04 Alarm tone (4 second duration)
05 Zone name
[991] Reset Keypad Programming to Factory Defaults
1. Press [*][8][Installer Code].
2. Enter [991].
3. Use the [<][>] keys to scroll to the applicable keypad.
4. Press [*] to select the keypad.
5. Re-enter [Installer Code].
6. Press [*] to reset the selected keypad to factory defaults.
(Valid entries are 000-128)
(Valid entries are 000-128)