Work Position; Correct Balance Of The Product - Husqvarna 545FR Manual Del Usuario

CAUTION: Do not use two-stroke oil for
water-cooled outboard engines, also
referred to as outboard oil. Do not use oil
for four-stroke engines.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
US gallon
1
2 1/2
5
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.
16
To fill the fuel tank
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap.
Two-stroke oil,
liter
2% (50:1)
0.10
0.20
0.30
0.40
3. Shake the container and make sure that the fuel is
US fl. oz.
4. Remove the fuel tank cap slowly to release the
2 ½
5. Fill the fuel tank.
6 ½
12 ⅞
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
Note: To see where the fuel tank is on your product,
refer to

Work position

•
•
•
•
•
•

Correct balance of the product

For forestry clearing, the product is correctly balanced
when it freely hangs horizontally from the suspension
WARNING: Obey the procedure that follows
for your safety.
fully mixed.
pressure.
CAUTION: Make sure that there is not
too much fuel in the fuel tank. The fuel
expands when it becomes hot.
refueling area and fuel source before you start the
engine.
Introduction on page 2 .
Hold the product with 2 hands.
Hold the product on the right side of your body.
Keep the cutting attachment below waist level.
Always keep the product attached to the harness.
Keep body parts away from the hot surfaces.
Keep body parts away from the cutting attachment.
1018 - 005 - 08.06.2020