To Start A Cold Engine - Husqvarna 545FR Manual Del Usuario

point. With correct balance, the risk of hitting stones if
you release the handlebar is decreased.
For grass clearing, the product is correctly balanced
when the blade is at cutting height near the ground.

To start a cold engine

1. Pull the choke control (A) up.
2. Push the decompression valve (B).
Note: The decompression valve moves to the initial
position when the product starts.
3. Push the air purge bulb (C) about 6 times or fuel until
fuel starts to fill the bulb. It is not necessary to fill the
air bulb fully.
A
1018 - 005 - 08.06.2020
B
C
4. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not step on the product.
5. Pull the starter rope handle slowly until you feel
some resistance. When you feel resistance, pull the
starter rope handle quickly and with force.
Note: Do not twist the starter rope around your hand.
6. Continue pull the starter rope handle until the engine
starts.
CAUTION: Do not pull the starter rope to
full extension and do not let go of the
starter rope handle. Release the starter
rope slowly. If you do not obey these
instructions it can cause damage to the
engine.
7. Set the choke control to the run position and apply
full throttle.
To start a warm engine (545F, 545FX,
545FXT)
1. Set the stop switch (A) to the start position.
2. Pull the choke control (B) up.
3. Set the throttle trigger (C) to the start position.
4. Push the air purge bulb (D) 10 times. It is not
necessary to fill the air purge bulb fully.
C
B
D
Note: Do not use the decompression valve (E).
5. Pull the starter rope handle quickly and with force.
Pull the starter rope handle until the engine fires.
A
E
17