Installation; Quick Start - Phonic FIREFLY 302 USB Manual Del Usuario

INSTALLATION

1. turn your computer on and connect the fire-
fly 302 USB to the computer via the included
USb cable. it is recommended not to turn
the unit's power on just yet, however.
2. Run the setup.exe file on the included driver
cd, and follow the installation instructions
displayed on screen.
3. When prompted to "disconnect and recon-
nect" the Firefly, change the power select
switch on the rear of the device to dc in.
4. Continue to follow the on-screen installation
instructions to finalize the setup.
5. open your audio editing / daW software,
and check the Firefly's ASIO driver has been
read successfully by the program. this is
usually done in the "devices" submenu. You
may also want to edit the Firefly's properties.
this is usually done by clicking on the tools
pull down menu, and selecting "Properties".
in this area, you can usually select the
Firefly's different inputs and outputs, and
assign them to various channels. this, of
course, depends on the software you are us-
ing, so check the software's user's manual
for more information.
2

QUICK START

1. Connect the DC converter to the 9-12V jack
in and change the power selector switch to
the dc in position.
2. Plug your USB cable into Firefly's USB port
and the other end into any available USb
port on your computer. Provided you have
already installed the required driver, the
computer should detect your Firefly 302
USb.
3. Connect a microphone to the XLR input
connector. talk into the mic and check the
led sig and clip indicators. adjust the Mic
level control as you see necessary.
4. connect any analog line inputs you wish to
use. We advise that you do not attempt to
use the 1/4" and rca connectors on any
one input channel at the same time.
5. Open your audio software and configure it so
the Firefly 302 USB is set as your input/out-
put device. Please note that the analog and
S/Pdif outputs cannot be used to output the
signal from the computer simultaneously.
6. Plug your headphones into the headphone
output of the Firefly to monitor the return
signal.
7. now you are ready to design high resolution
audio productions.
Firefly 302 USB