Usb 2.0 Interface; System Requirements; Driver Installation - Phonic FIREFLY 302 USB Manual Del Usuario

Ocultar thumbs Ver también para FIREFLY 302 USB:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USB INTERFACE

SYSTEM REQUIREMENTS

The following are the minimum required specifications for use with the Firefly 302 USB. If your com-
puter does not meet these requirements, you will experience lagging of audio and possible freezing
of your computer when attempting to operate the Firefly.
Windows
• Microsoft® Windows® XP (with SP2), Microsoft® Windows® Vista or Microsoft® Windows® 7
• Available USB 2.0 port
• Intel Pentium® 4 processor or equivalent AMD Athlon processor
• Motherboard with Intel or VIA chipset
• 5400 RPM or faster hard disk drive (7200 RPM or faster with 8 MB cache recommended)
• 256 MB or more of RAM (512 MB recommended)
Macintosh
• OS X Leopard 10.5.1 or later with USB support (OSX 10.8 currently not supported)
• Intel Core 2 Duo or later processor (G4 processors are not supported)
• 256 MB or more of RAM (512 MB or more recommended)

DRIVER INSTALLATION

To use the Firefly efficiently (or at all) on any computer, it is important to install all the necessary
drivers from the included cd. We advise that users read all instructions carefully before continu-
ing on to each step of the installation process, as they will be asked to, however disconnect and
reconnect their Firefly.
Windows XP (with Service Pack 1 or 2)
1.
it is recommended that you quit all applications before starting the installation process.
2.
Connect the Firefly 302 USB to the computer, leaving the power of the unit off.
3.
Insert the installation CD included with your Firefly into the CD-ROM drive of your computer. If
the cd does not automatically start the installation process within a few moments, then navigate
to "My Computer" → your CD-ROM drive → "Firefly302USB_Driver" → double-click "setup.exe"
to begin the installation manually. The Firefly Control Panel software also will be installed at this
time.
4.
Follow the on-screen installation instructions, turning the Firefly on when asked to 'disconnect
and reconnect' the unit.
Firefly 302 USB
5

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido