Rear Panel Description - Phonic FIREFLY 302 USB Manual Del Usuario

8 9

REAR PANEL DESCRIPTION

8. Analog 1/4" TRS Inputs 1 and 2
these are balanced 1/4" trS line inputs and can
be used to connect any line level devices, such as
cd players or dat recorders.
9. Analog RCA Inputs 1 and 2
these are rca inputs and can be used to connect
any device like cd players, dat recorders, turn-
tables, and even analog mixers (taking the signal
from a mixer's Record or 2 track outputs).
Important Note: Keep in mind that the two rca inputs are
completely independent of one another; however these
inputs should not be used if the corresponding 1/4" analog
1 and 2 inputs are used, as doing so would have quite
undesirable results. You can, however, mix and match
these inputs. If, for example, you wanted to use Input 1's
RCA connector and Input 2's 1/4" connector that would
not cause any problems.
10. Analog 1/4" TRS Outputs 1 and 2
this are balanced 1/4" trS line outputs with line
level signal (+4dBu). Use them to get a stereo
output channel and connect them to active moni-
tors (such as the Phonic P8a), or perhaps to an
amplifier and a passive pair of speakers. You could
also use them with signal processors, mixers or
other external devices.
11. Analog RCA Outputs 1 and 2
these are rca line outputs. they accept rca
cables and can be connected to any external de-
vice that uses rca connectors. this could include
tape recorders and MP3 recorders.
4
10 11 12
12.
these are a standard S/Pdif digital audio in-
put/outputs that can be use with digital mixers,
dat recorders, or any external device that uses
this Digital format. The S/PDIF's output sampling
rate is determined by the sampling rate set by
the Firefly control software. Please use a 75 ohm
coaxial cable with rca plug if you are using the
S/Pdif connection, as the most common problems
associated with glitches in digital interfaces are the
result of using poor quality cables.
13.
You can have 16 simultaneous MIDI input/output
channels sent to and from your computer through
the Firefly 302 USB.
14.
this is a digital USb 2.0 connector that you can
use to connect to your computer. doing so allows
users to send their audio signal from the Firefly to
the computer, and vise-versa.
15.
connect the supplied dc converter to this jack to
feed the unit. Please only use this dc converter in
order to ensure no damage is done to the Firefly. If
for any reason your converter gets lost or damaged
and you need a replacement, please contact your
local Phonic dealer.
16.
Use this switch to turn the Firefly 302 USB on
and off.
13 14 15
S/PDIF In/Out
MIDI In/Out
USB Port
9-12VDC Input Power Jack
Power Switch
Firefly 302 USB
16