Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO ASSEMbLE AND USE
•
Attach steamer head to steamer body.
•
Secure steamer head with the small Philips Head Screw until is fully tightened.
•
Insert steamer handle down into the steamer body.
•
Screw the Large Philips Head screw through the opening at the back of
steamer body into the rear of the steamer handle and tighten until secure.
•
Place the steamer head in cloth pad, fasten pad by pulling the cord while
pressing on Toggle.
NOTE: Do not operate without a floor cloth in place.
•
Remove Water tank by lifting straight up and away from the unit, unscrew
cap of the Water tank, remove the insert assembly, fill with cool tap water,
replace the insert assembly and replace and tighten the cap. Replace
Water Tank back to the unit.
•
Twist the Quick Release Cord Wrap clockwise to unwrap the Power Cord
completely and plug into a grounded outlet.
•
The LED will illuminate when the steamer is connected to power socket.
Please wait for 20 seconds (heat up period) before pressing trigger.
The steam unit is now ready for use.
NOTE: It is recommended that another high wattage appliance is not
operated on the same circuit to avoid a circuit overload.
•
Slowly pass over surface to be cleaned while pressing trigger to emit steam.
Hold the steam switch as you are cleaning for periods of up to 3-5 seconds.
Holding the steam switch continuously will cause the unit to release water.
It is recommended to sweep or vacuum floor prior using the steamer.
CAUTION: To sanitize an area of your floor, leave the steamer over area for
a minimum of 3 seconds, but no longer than 5 seconds. Leaving the
steamer stationary for a longer period than recommended may cause the
build up of a pale residue. This residue can be removed by using a
decalcifying product or with a few drops of vinegar. (See troubleshooting guide)
WARNING: Never run the steamer without water. Never direct steam at any
person or animal. Use steamer on sealed hard floor only.
•
When steamer stops emitting steam, this will occur after approximately 30
minutes of use, simply remove the Water tank, refill, and continue cleaning.
•
When you finish your cleaning, unplug Power cord from outlet, empty the
Water tank, carefully remove the Cloth Pad from Steamer Head, wind Power
Cord around the Cord Wrap and store it upright in a dry area or hang by
the storage hook.
CAUTION: The cloth pad may be very hot.
05
Publicidad
Tabla de contenido
