Low Battery Warning; Assembly And Adjustments - DeWalt DCD997 Manual De Instrucciones

English

CAUTION: Remove all accessories from the chuck
before using the drill as a spotlight. Personal injury or
property damage could result.

Low Battery Warning

When in spotlight mode and the battery is nearing
complete discharge, the spotlight will flash twice and then
dim. After two minutes, the battery will be completely
discharged and the drill will immediately shut down. At this
point, replace with a fresh battery.

WARNING: To reduce the risk of injury, always have a
back-up battery or secondary lighting available if the
situation warrants it.
Keyless Single Sleeve Chuck (Fig. G–I)

WARNING: Do not attempt to tighten drill bits (or
any other accessory) by gripping the front part of the
chuck and turning the tool on. Damage to the chuck
and personal injury may result. Always lock off trigger
switch and disconnect tool from power source when
changing acces sories.

WARNING: Always ensure the bit is secure before
starting the tool. A loose bit may eject from tool
causing possible personal injury.
Your tool features a keyless chuck
sleeve for one-handed operation of the chuck. To insert a
drill bit or other accessory, follow these steps.
1. Turn tool off and disconnect tool from power source.
2. Grasp the black sleeve of the chuck
and use the other hand to secure the tool as shown
in Figure G. Rotate the sleeve counterclockwise (as
viewed from the front) far enough to accept the
desired accessory.
3. Insert the accessory about 3/4" (19 mm) into the chuck
and tighten securely by rotating the chuck sleeve
clockwise with one hand while holding the tool with
the other hand. Continue to rotate the chuck sleeve
until several ratchet clicks are heard to ensure full
gripping power.
Be sure to tighten chuck with one hand on the chuck sleeve
and one hand holding the tool for maximum tightness.
To release the accessory, repeat Steps 1 and 2 above.
Table 1
Customizable Features
Worklight brightness
Worklight delay off
Maximum speed (RPM) in drill
mode
Bind-Up Control®
10
6 with one rotating
with one hand
6
Home
MED
20 secs
Speed 1 450
Speed 2 1300
Speed 3 2000
Disabled
Fig. G Fig. H
6

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury. Exception—
Tool Connect™ functions and mode adjustments
require battery to be installed.
Mode Selector (Fig. A, J)

WARNING: To reduce the risk of injury, remove
accessories from the tool chuck before using the
mode selector.
Your tool is equipped with a mode selector that allows 3
modes to be customized using the Tool Connect™ app.
Home settings are active when the home indicator
lit. The following 4 features can be customized. For more
information, refer to Table 1 below.
Once configured, pressing the mode selector button
the foot of the tool will cycle through the modes
If you are unsure of the current configuration, press the
mode selector button 14 to set the tool to the Home
setting (home indicator 15
Fig. J
14 15
Factory Presets
Mode 1 Mode 2
OFF MED
20 secs 20 secs
450 450
1300 1300
2000 2000
Disabled Disabled
Fig. I
15 is
14
16 .
is lit).
16
Mode 3 Customizable Range
HIGH OFF-HIGH
20 minutes 0–20 minutes
450 140–450
1300 400–1300
2000 600–2000
Disabled Disabled/Enabled
on