Vortice VORT-ICE GO 12K Manual De Instrucciones página 32

ENGLISH
Sleep Function
1. In cooling mode, by pressing the SLEEP button, the set temperature will increase 1°C at the 1st hour, another 1°C at
the second hour, and then will remain at that temperature.
2. In sleep mode, the ventilation will remain at low speed. Press the SLEEP button again to return the temperature and
ventilation settings to the pre-selected ones.
3. The unit will shut down automatically after the SLEEP function has been running for 12 hours.
4. Please note, the sleep function is not available while the Ice Go is working in ventilation,
dehumidification or auto mode. It is available in Cooling mode only.
Dehumidify (DRY) mode
In dehumidify (DRY) mode, the temperature cannot be adjusted and the ventilation will work at low speed. When the unit
is operating in Dehumidify (DRY) mode, humidity extracted from the air is collected in an internal tank. If the tank
becomes full, the compressor and motor shut off automatically thanks to the HydroSafe Technology. At the same time,
the "Water Full" indicator comes on. An alarm will also sound. When the tank is full, drain the water as shown in the
"DRAINAGE" section. You may also use the unit without having to empty the tank by setting up continuous drainage with
the included hose, please also refer to the page about "DRAINAGE".
Vita-Ion Ionizer
Vita-ion is a purifier technology that helps eliminate the negative effects of dust, unhealthy volatile chemicals, as well as
bacteria and viruses, allowing you to breathe cleaner air.
Remote control
All the above functions can also be performed with the supplied remote control.
This remote control requires 2 pcs AAA batteries to operate, included with the unit.
Self-diagnosis
This machine is equipped with a self-diagnosis function. If anything in the Vort-Ice Go is faulty,
the display will show the word "E1" or "E2". If this occurs, please contact a certified service
center.
Eco-H2O Efficiency Boosting
With the new Eco-H2O technology the Ice Go allows maximum energy efficiency by recycling condensed
water in conditions where moisture allows it or by having the user manually adding water to the equipment
in drier environments.
The working principle is: while the machine is working, the condenser gets hot. The water will cool down
the condenser, bringing energy savings by increasing the efficiency of the heat exchanger.
In normal conditions the Vort-Ice Go does not need you to add or drain any water, as it will be recycled by the Eco-H2O
system. In unusually dry conditions, to use this function, it is recommended 1.2L of water
be added to the air conditioner:
1. Pull out the water funnel
2. Add 1,2 l water to the funnel
NOTE:
Only add extra water after at least one hour of operation, as the unit itself will generate
water it will recycle. Never add over 1.2L of water, otherwise the Hydro-Safe Technology
will turn on the "water full" indicator and the unit will stop working.
In case the "water full" indicator lights up, please drain the water from the drain point
at the back side of the unit until the red light goes out.
32
SPEED UP
TIMER
Fig. 18
Fig. 19