Drainage - Vortice VORT-ICE GO 12K Manual De Instrucciones

ENGLISH
IMPORTANT
To prolong the compressor's life, after switching-off the unit, please wait for 3 minutes before switching the unit back on.
The cooling system will switch off automatically once the ambient temperature reaches the desired set level. The fan,
however, keeps working at the set user speed. If the ambient temperature rises above the selected level, the cooling
system will return automatically to work.

Drainage

When the unit is operating in Cooling mode, with humidity conditions higher than 95%, a drainage free operation is
guaranteed for up to 16 hours. If the tank becomes full, the compressor and motor will turn off automatically. At the same
time, the "Water Full" indicator comes on. An alarm will also sound. When the tank is full, carry out the following
instructions:
1. Turn off the air conditioner and avoid moving it when full.
2. Position a container (a water tray for example) underneath the drain hole.
3. Remove the drain plug & rubber plug from the drain hole and allow
the water to drain out.
4. Replace the rubber plug and tighten the drain plug firmly.
5. Switch the unit back on.
The unit does not require tank drainage when the humidity conditions are less
than 95%. For conditions greater than 95%, a free drainage operation is
guaranteed for up to 16 hours. Should you prefer to use the appliance without
having to empty the tank in a high humidity environment,
proceed as follows:
Fig. 21
Rubber plug
Connect the drain tube to the water outlet as shown and locate the
other end into a drain. The drain tube may be extended by adding an extension tube
and using a suitable connector.
Supply drain
Fig. 23
tube
Remove the drain plug and rubber plug and retain for future use.
Drain Knob
Note:
The drain must be below the outlet level.
If you want to extend the water tube, you can connect it with another
Extended drain tube
tube (Ø 18 mm).
(Ø 18 mm)
Drain hole
Rubber plug
Fig. 22
Fig. 20
Drain Knob
Drain tube
33