Operating Modes; Man And Aut Modes; Man Mode - ITALFARAD PFC96evo Manual De Instrucciones

There are two possible operating modes, listed below:
 The icons AUT and MAN indicate the operating mode automatic or manual.
E
 To change the mode, press and hold the
N
 The operating mode remains stored even after removing and reapplying the power supply voltage.
 When the unit is in manual mode, you can select one of the steps and manually connected
or disconnect it.
 In addition to the specific icon, the alphanumeric display shows MAN in order to highlight
the manual mode condition. Press
 While the display shows MAN, it is possible to select the step to be switched on or off. To
select a step, use the
 Press
 If the selected step has not yet exhausted the reconnection time, the
to indicate that the transaction has been accepted and will be conducted as soon as
possible.
mode icon
inserited in
Tel.+39 051 6618311 Fax +39 051 6605594 E-mail: italfarad@italfarad.com Web: www.italfarad.com
or
to activate or deactivate the selected step.
MAN
Tot kvar
MAN
Select step
ITALFARAD S.p.A. via IV novembre n.1 Minerbio Bo Italy

Operating modes

MAN and AUT modes

button for 1 sec.

MAN mode

to view the other measurements as usual.
buttons. The selected step will flash quickly.
Change step status
icon will flash
Connected
steps
Manual step
selection
enabled
38