ITALFARAD PFC96evo Manual De Instrucciones página 108

Measure
Delta-kvar
E
Voltage
N
Current
Weekly PF
THD cap.
Temperature °C °F Temperature of internal sensor.
Voltage THD THDV Total harmonic distortion % (THD) of plant voltage.
Current THD
Cosø setpoint
Step power
Step counter
Step hours
 These measures are shown only if the Step trimming function is enabled (P.25=ON) and the
advanced password is enabled and entered.
Tel.+39 051 6618311 Fax +39 051 6605594 E-mail: italfarad@italfarad.com Web: www.italfarad.com
Icon Description
Kvars needed to reach the cosø setpoint. If delta-kvar is positive cpacitors
Δkvar
need to be inserted, if negative to be disconnected.
kvar Total kvar of the plant.
ΔSTEP Number of equal steps to achieve the target power factor.
RMS voltage of the plant current.
V
V HI Maximum voltage value measured.
A RMS current of the plant voltage.
A HI Maximum current value masured.
WPF Weekly average power factor.
PF Instantaneous total power factor.
THDC Capacitors total harmonic distortion (THD) in current.
TC.HI Maximum THD value measured.
°CHI
°FHI Maximum temperature value measured.
VH02...
...VH15 % voltage harmonic content from 2.nd up to 15.th order
THDI Total harmonic distortion % (THD) of plant current.
IH02...
...IH15 % Current harmonic content from 2.nd up to 15.th order
IND
Setting of desired cosø setpoint (same as P.19).
CAP
 Step residual power, as a percentage of the set rated power.
%
OPC  Operation counter of the step.
 Hour meter of the step insertion.
H
ITALFARAD S.p.A. via IV novembre n.1 Minerbio Bo Italy
40