Ir Programming Port; Parameter Setting With Pc - ITALFARAD PFC96evo Manual De Instrucciones

 The parameters of the PFC96evo regulator can be configured through the front optical port,
using the IR-USB programming dongle, or with the IR-WiFi dongle.
 This programming port has the following advantages:
 You can configure and service the PFC96evo regulator without access to the rear of the
device or having to open the electrical panel.
 It is galvanically isolated from the internal circuits of the PFC96evo regulator,
guaranteeing the greatest safety for the operator.
 High speed data transfer.
 IP54 front panel protection.
 Limits the possibility of unauthorized access with device configuration since it is
necessary to have the IR-USB or IR-WI-FI dongles.
 Simply hold the dongle up to the front panel, connecting the plugs to the relevant
connectors, and the device will be acknowledged as shown by the LINK LED on the
programming dongle flashing green.
 You can use the PFC Remote monitoring software to transfer (previously programmed) set-
up parameters from the PFC96evo regulator to the hard drive of the PC and vice versa.
 The parameter may be partially transferred from the PC to the PFC96evo regulator,
transferring only the parameters of the specified menus.
Tel.+39 051 6618311 Fax +39 051 6605594 E-mail: italfarad@italfarad.com Web: www.italfarad.com

IR programming port

Parameter setting with PC

ITALFARAD S.p.A. via IV novembre n.1 Minerbio Bo Italy
E
N
43