Commands Menu - ITALFARAD PFC96evo Manual De Instrucciones

 The commands menu allows executing some occasional operations like reading peaks
resetting, counters clearing, alarms reset, etc.
 If the Advanced level password has been entered, then the commands menu allows
executing the automatic operations useful for the device configuration.
 The following table lists the functions available in the commands menu, divided by the
access level required.

With controller in MAN mode, press

Press
to select CMD.

Press to access the Commands menu.

Select the desired command with

Press and hold for three seconds
PFC96evo regulator shows OK? with a countdown.

If you press and hold
while if you release the key before the end, the command is canceled.
COD COMMAND
C01 RESET MAINTENANCE
C02 RESET STEP COUNT
C03 RESET STEP TRIMMING Adv. Reload originally programmed power into step trimming.
C04 RESET STEP HOURS
C05 Reset max VALUES
C06 RESET WEEKLY TPF
C07 SETUP TO DEFAULT
C08 SETUP BACKUP
C09 SETUP RESTORE
Tel.+39 051 6618311 Fax +39 051 6605594 E-mail: italfarad@italfarad.com Web: www.italfarad.com

Commands menu

or
if you want to execute the selected command. The
until the end of the countdown the command is executed,
PSW DESCRIPTION
Usr. Reset maintenance service interval.
Adv. Reset step operation counters.
Adv. Reset step operation hour meters.
Adv. Reset maximum peak values.
Usr. Resets weekly total power factor history.
Adv. Resets setup programming to factory default.
Adv. Makes a backup copy of user setup parameters settings.
Usr. Reloads setup parameters with the backup of factory settings.
ITALFARAD S.p.A. via IV novembre n.1 Minerbio Bo Italy
button for 5 seconds.
E
N
57