General Parts Knowledge; Assembly - Delta ShopMaster Manual De Instrucciones

BLADE GUARD
TABLE
SCALE
FENCE RAIL
HEIGHT
ADJUSTMENT
WHEEL
MITER
GAUGE
ON/OFF
SWITCH
BEVEL
LOCK
The part and hardware names and letters correspond to those shown in General Parts Knowledge, Shipping Contents, and the
Hardware Contents.
When lifting saw, hold it close to your body while lifting.
Keep knees bent and lift with your legs, not your back.
Fully assemble saw with stand assembly prior to use. Stand
assembly is an integral and necessary part of the support
structure for this saw. Do not attempt to substitute a table or
other surface for the stand assembly. Do not modify saw, or
create accessories not recommended for use with this saw.
NOTE:
Before assembling stand to saw, unlock bevel lock, tilt
blade/motor assembly and remove Styrofoam piece from under
saw motor. The bevel lock is the handle located underneath
the blade height adjustment wheel (Fig. 1).

GENERAL PARTS KNOWLEDGE

ASSEMBLY

Do not connect to power supply until assembly is complete.
Make sure power switch is in "OFF" position before connecting
to power supply.
Avoid contact with blade teeth. Keep blade stored or lowered
when possible.
10
ANTI-KICKBACK
PAWLS
THROAT PLATE
RIP FENCE
PUSH STICK
RIVING KNIFE
BEVEL SCALE
STYROFOAM
Figure 1