Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING:
Do not allow familiarity with this product to make you careless.
Remember that a careless fraction of a second is sufficient to
inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to comply
with ANSI Z87.1or equivalent standard, along with hearing
protection. Failure to do so could result in objects being thrown
into your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not recommended
by the manufacturer of this product. The use of attachments or
accessories not recommended can result in serious personal
injury.
Applications
You may use this product for the purposes listed below:
• Grinding metals
• Sanding wood or metal surfaces
WARNING:
Battery products are always in operating condition. Therefore,
the on/off switch should always be in the OFF position when not
in use or carrying at your side.
Installing / Removing Battery Pack
See Figure 3, page 14.
To install:
• Place the on/off switch in the OFF position.
NOTE: If the on/off switch is in the ON position when the
battery is installed, the overload LED will flash and the tool
will not function. If this occurs, turn the tool off and back on
to begin use.
• Insert the battery pack.
• Make sure the latches on each side of the battery pack snap
in place and that battery pack is secured in the product before
beginning operation.
To remove:
• Depress the latches on each side of the battery pack.
Starting / Stopping the Grinder
See Figure 4, page 14.
• To turn the angle grinder on, push the on/off switch forward to
the ON position. To lock the grinder in the ON position, depress
the front of the switch.
• To stop the grinder, place the on/off switch in the OFF position.
If the switch is in the locked position, depress the rear of the
switch.
Never cover air vents. They must always be open for proper
motor cooling.
Positioning the Guard
See Figures 5 - 7, page 15.
The guard on the grinder should be correctly positioned
depending on which side the handle is mounted. Never use the
grinder without the guard correctly in place.
WARNING:
Never place the guard so that it is in front of the grinder. This
could result in serious injury because sparks and loose particles
thrown from the grinding wheel would be directed toward the
operator. Always place the guard in the correct location as
shown.
To reposition the guard:
• Remove the battery pack.
• Depress lever and rotate the guard to its correct position as
shown.
NOTE: Be sure the raised ridge on the guard is seated in the
groove on the bearing cap. Never use the grinder without the
guard in place and properly adjusted.
10 - English
:
Publicidad
Tabla de contenido
