Electrical Hook-Up - Corghi LaserLine EM 9580 Plus Manual De Uso

After assembling the machine, position it in the
selected place and make sure that the spaces
surrounding it are at least equal to the ones
indicated in fig.10.
Main working elements of the
machine (fig. 11)
A) Automatic diameter and distance measur-
ing arm
B) Automatic width measuring Ultrasonic
sensor (optional)
52
C) Head
D) LCD Monitor
E)
F) Side flange holder
G) Top weight tray
H) Wheel support shaft
I)
L) Control pedal C of the automatic wheel
The wheel balancer is set up by the manufacturer
to operate with the power supply available in the
place of installation. The set-up data for each
machine are given on the machine data plate and
on a special label attached to the power supply
connection cable.
Any operations for hooking up to the workshop
electrical board must be carried out only by
10
qualified technicians in compliance with the
regulations in force, under the responsibility
and at the charge of the customer.
The electrical hook-up must be performed
according to:
• Absorbed power specifications indicated on
the machine data plate.
• The distance between the machine and the
electric hook-up point, so that voltage drops
under full load do not exceed 4% (10% when
starting up) of the rated voltage specified on
the data plate.
- The user must:
• Connect the machine to its own electrical con-
nection fitted with a suitable 30-mA current
sensitive circuit breaker.
• Power line fuses in accordance with specifica-
tions in the main wiring diagram of this manual.
• Provide the workshop electric installation with
an efficient grounding circuit.
- Prevent unauthorised use of the machine, al-
ways disconnect the power supply plug when
the machine is not used (switched off) for
extended periods of time.
11
- If the machine is connected directly to the power
supply by means of the main electrical board
and without the use of a plug, a key-operated
or padlockable switch must be installed to
restrict machine use exclusively to qualified
personnel.
EM 9580 Plus - EM 9580 C Plus - Operator's manual
Kis control keypad
Wheel guard
clamping system

ELECTRICAL HOOK-UP

WARNING