Corghi LaserLine EM 9580 Plus Manual De Uso página 70

if necessary, into equal parts on the two sides;
procedure described in the STATIC BALANCING
section.
Motorcycle Dynamic
Programme
Proceed as follows to balance a motorcycle
wheel on two planes (dynamic balancing) using
clip weights:
- Fit the motorcycle wheel adapter on the wheel
balancer (A fig. 26).
• remove the hub;
• Insert the two screws provided into the holes
on the wheel contact flange.
• Tighten the screws on the adapter making
sure that it rests on the flange correctly.
• mount the motor shaft on the adapter.
• Mount the wheel after selecting the centring
cones (one for each side of the wheel), tighten
with the appropriate ring nut using the spacers
necessary for coupling the securing cones to
the threaded part of the shaft.
IMPORTANT: the wheel must be fixed to the
flange so as to avoid any movement of the two
during the spin or braking phases.
- Select the Balancing Programme
icon then, pressing the Kis knob or the enter
button, set the MOTORCYCLE environment
- Mount the appropriate extension on the
internal measuring arm (B, fig. 26b).
70
- Set the wheel's data as indicated in the "WHEEL
DATA ENTRY" chapter.
- Perform a spin.
- Proceed as described for dynamic balancing.
Proceed as follows to balance motorcycle wheels
dynamically using adhesive weights:
- Follow the instructions for mounting the motor-
cycle adapter described in the MOTORCYCLE
DYNAMIC PROGRAMME.
26a
Proceed as
cycle Dynamic" programme.
- Perform a spin.
- at the end of the spin, select the balancing
programme icon
knob or the ENTER button until the required
programme is selected.
- For the application of the adhesive weight, use
6 o'clock as the reference if the "LASER" confi-
guration is active and 12 o'clock if the "H12" or
"CLIP" configuration is active.
- When applying the adhesive weight, always
use the 12 o'clock position as your reference,
regardless of the setting made in the Adhesive
Weight Application Position configuration.
Best results can be achieved if the adhesive
weights are positioned with the outer edge being
flush with the rim edge.
Some rims have spokes so wide that it is not
possible to place adhesive weights next to them;
a program which divides the counterweights
EM 9580 Plus - EM 9580 C Plus - Operator's manual
Motorcycle ALU Programme
described previously for the "Motor-
Split Weight Programme
26b
and press the Kis