Ryobi P635 Manual Del Operador página 8

WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
cONNEcTING/DIScONNEcTING PAINT
SUPPLy TUbE TO bAckPAck PAINTER
See Figures 2 - 3, page 15.
Paint travels from the tank on the backpack unit to the
sprayer or roller through the paint supply tube.
NOTE: If your paint supply tube has different ends, the end
with the check valve should be connected to the backpack
unit and the end without the valve should be connected to
the sprayer or roller.
to connect the paint supply tube to the machine:
 Push the connector on the end of the paint supply tube
into the quick-connect main outlet until it clicks. Pull on
the tube to be certain it is properly secured.
to disconnect the paint supply tube from the machine:
 Hold the tube in your hand and push the release
button.
ASSEMbLy
aSSEMBlinG thE paint rollEr
See Figure 4, page 15.
 Place roller caps in each end of the paint roller.
 Align pins in the end of each roller cap to the holes inside
the roller head. Push out on the side of the roller head
until the roller snaps into place.
 Depress the latches on the sides of the roller handle.
 Insert the collar on the roller head into the hole in the
handle until fully seated.
 Release the latches to secure the roller head.
connEctinG thE paint SupplY tuBE to
thE paint rollEr aSSEMBlY or poWEr
PAINT SPRAyER
See Figure 5 - 6, pages 15 - 16.
connecting the paint supply tube to the sprayer:
 Push the connector on the end of the paint supply tube
into the quick-connect main outlet until it clicks. Pull on
the tube to be certain it is properly secured.
 Leaving a small amount of slack in the supply tube, pinch
the tube lightly and place it through the opening in the
paint sprayer, beginning at the rear. To raise the barrier
so the supply tube can be placed in the front, depress
the switch trigger.
NOTE: Push the tube all the way to the back of the
opening.
 Release the trigger to lower the barrier, then pull gently
on the supply tube at the back of the paint sprayer to
make sure the tube is seated securely.
 Plug the sprayer's DC power cord into the outlet on the
backpack unit.
connecting the paint supply tube to the roller
assembly:
 Push the connector on the end of the paint supply tube
into the quick-connect main outlet until it clicks. Pull on
the tube to be certain it is properly secured.
8 — English