brennenstuhl Primera-Tec Automatic 19.500 A Instrucciones De Uso página 15

041610 Primera-Tec_041610 Primera-Tec Automatik 1 0487903 1
Primera-Tec Operating Instructions
device must be connected to an outlet with a
properly installed protective ground. In case of a
direct lightning strike, due to the extremely high
energy generated, complete protection of the
connected devices cannot be guaranteed. You can
get the highest level of surge protection with a
multi-level concept consisting of coarse and me -
dium protection (installation technology) together
with our fine protection per EN 61643-11 type 3.
After start-up, the "Protection on" signal light
illuminates to confirm that the protection is
functioning. If the lamp is no longer lit, the surge
protector has been used up and the outlets are
disconnected from the voltage. In this case, the
protective elements were overloaded by very high
voltage surges and the device must be replaced.
Permanent sockets
The permanent sockets are surge protected and,
independent from the digital Master-Slave
function, always on as soon as the main switch is on.
Digital Master-Slave function
With the switching on/off of one single device,
which is plugged into the master socket, all furt-
her appliances in the slave sockets can also be
automatically switched on/off. For example, you
can use a computer as a master device, which can
embrace slave appliances in the automatic control
such as, for example, monitor, printer, modem etc.
15