Cutter Blade Assembly And Disassembly And Adjustment Of Cutter Blade Height - Hitachi P 20SB Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
2. Surface cutting;
Rough cutting should be accomplished at large cutting depth and at a suitable speed so
that shavings are smoothly ejected from the machine. To ensure a smoothly finished
surface, finish cutting should be accomplished at small cutting depth and at low speed.
3. Beginning and ending the cutting operation:
As shown in Fig.4, place the front base of the planer on the workpiece and support the
planer horizontally. Turn ON the power switch, and slowly operate the planer toward the
leading edge of the workpiece. Firmly depress the front half of the planer at the first stage
of cutting and, as shown in Fig.5, depress the rear half of the planer at the end of the
cuning operation.
The planer must always be kept flat throughout the entire cutting operation.
Fig. 4 Beginning of cutting operation
4. Precaution after finishing the planing operation:
When the planer is suspended with one hand after finishing the planing operation, ensure
that the cutting blades (base) of the planer do not contact or come too near your body.
Failure to do so could result in serious injury.
CUTTER BLADE ASSEMBLY AND DISASSEMBLY AND
ADJUSTMENT OF CUTTER BLADE HEIGHT
WARNING:
1. Cutter blade disassembly:
(1) As shown in Fig.6 use the accessory box wrench to
withdraw the three bolts used to retain the cutter
blade, and remove the cutter blade holder.
12
Be sure to switch power OFF and disconnect the plug from the recep-
tacle to avoid serious trouble.
Be careful not to injure your hands.
Fig. 5 End of cutting operation
Box wrench
Bolt
Fig. 6
Blade
holder

Publicidad

Tabla de contenido
loading

Tabla de contenido