Carbide Blade Assembly And; Blade Height; Double Edged Blade Type - Hitachi P 20DA Manual De Instrucciones

English
CARBIDE BLADE ASSEMBLY AND DISASSEMBLY AND
ADJUSTMENT OF CUTTER BLADE HEIGHT
WARNING:
Be absolutely sure to attach and de-
tach the planer blade and adjust its
height in a state where the battery is
removed from the unit.
CAUTION:
Be careful not to injure your hands.
< Double edged blade type >
1. Carbide blade disassembly:
(1) As shown in Fig 10, loosen the blade
holder with the attached box wrench.
(2) As shown in Fig 11, remove the carbide
blade by sliding it with the attached box
wrench.
2. Carbide blade assembly:
CAUTION:
Prior to assembly, thoroughly wipe
off all swarf accumulated on the car-
bide blade.
(1) As shown in Fig. 12, lift set plate (B) and
insert the new carbide blade between
cutter block and set plate (B).
(2) As shown in Fig 13, mount the new carbide
blade by sliding it on the set plate (B) so
that the blade tip projects by 1mm from
the end of the cutter block.
18
Box Wrench
Blade Holder
Fig. 10
Carbide Blade
Fig. 11
Fig. 12
End of
Setplate (B)
Back Metal
Fig. 13
Bolt
Housing
Groove
Carbide Blade
Set Plate (B)
Housing
Groove