Mounting Of Cutter Blade Or Nylon Cutting Head - Makita EM4250 Manual De Instrucciones

MOUNTING OF CUTTER BLADE OR NYLON CUTTING HEAD

Turn the machine upside down, and you can replace the cutter blade easily.
For EM4250, EM4251
– Insert the hex wrench through the hole in the gear case and rotate the
receiver washer (3) until it is locked with the hex wrench.
– Loosen the nut (1) (left-hand thread) with the socket wrench and remove the
nut (1), and clamp washer (2).
For EM4250 with the hex wrench still in place.
– Mount the cutter blade onto the shaft so that the guide of the receiver washer
(3) fits in the arbor hole in the cutter blade. Install the clamp washer (2) and
secure the cutter blade with the nut (1).
[Tightening torque: 13 - 23 N-m]
NOTE: Always wear gloves when handling the cutter blade.
NOTE: The cutter blade-fastening nut (with spring washer) is a consumable
part. If there appears any wear or deformation on the spring washer,
replace the nut.
Mounting of nylon cutting head
For EM4251
– To install the nylon cutting head (7), remove the tightening nut (8).
– Insert the socket-head wrench (11) through the hole in the gear case and tum
the support washer until it will be locked with its notch (12) (or the shaft will
be locked).
– Then screw the nylon cutting head onto the shaft by turning it
counterclockwise.
– Remove the socket-head wrench.
– Make sure that the blade is the left way up.
(3)
Rotation
11
(2)
Hex wrench
(11)
(12)
(7)
(8)
(1)