Nylon Cutting Head - Makita HRU01 Manual De Instrucciones

damage to the tool or battery cartridge.
If the tool becomes overloaded but not locked up, a
protector is provided to reduce the revolutions to protect
the motor. In this case the two indicator lamps described
in the table below do not light or blink.
All other protection functions can be identified by the
indicator lights described in the table below.
- Blinking
- Lighting On
Blinking
Lighting On
Blinking Blinking
010823

Nylon cutting head

NOTICE:
Do not attempt to bump feed the head while the tool
•
is operating at a high RPM. Bump feeding at a high
RPM may cause damage to the nylon cutting head.
The bump feed will not operate properly if the head
•
is not rotating.
1
012863
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To feed the nylon cord, bump the cutting head against the
ground while rotating at a low RPM. The nylon cord is
Status
Battery power has been
nearly used up.
Battery protector is
shutting off the power -
battery power has been
used up.
Overload protector is shutting
- off the power - the motor was
locked.
Overheat protector is shutting
-
off the power - overheating.
Electric or electronic
malfunction
1. Most effective
cutting area
1
012967
Action to be taken
Replace the battery with fully charged one.
Replace the battery with fully charged one.
Release the switch trigger and remove the
cause of the motor lock or overload. If the
cutting tool is locked by entangling weeds or
the like, always remove the battery cartridge
before clearing it.
Rest the equipment for a while.
Ask your local authorized service center for
repairs.
automatically cut to the proper length by the cutter on the
protector.
NOTE:
If the nylon cord does not feed out while bumping
•
the head, rewind/replace the nylon cord by
following the
"Maintenance."
Do not bump the tool to the concrete or asphalt
•
surface. Bumping to this kind of objects may cause
the tool damage.
8
1. Indicator lamps
procedures described under