Memory Backup; Preset Tuning - Teac AG-790 Manual Del Usuario

TUNING MODE TUNING/PRESET
BAND MEMORY
Manual Memory Presetting
You can store FM and AM stations from Channel 1 to 30
respectively.
1
Tune in a station you want to listen to (see steps
4 of page 13).
2
Press the MEMORY button.
3
While the "MEMORY" indicator is blinking, select a
preset channel to store the station using the
TUNING/PRESET buttons, and then press the MEMORY
button.
To store more stations, repeat steps

Memory Backup

If the POWER switch of the main unit is turned off or the
power supply is interrupted for 3 days or longer, all the
settings kept in memory (such as preset stations) will be
erased.
To avoid loosing your preset stations, it is advisable to keep
your AG-790 in the STANDBY mode when not in use.
14

Preset Tuning

1
to
1 to 3 .
How to select preset stations
1 Select AM or FM by pressing the BAND button.
2
If "CH" indicator is not lit, press the TUNING MODE
button to select the preset tuning mode.
3
Select a preset channel using the TUNING/PRESET
buttons.
Memory Scan
1. Select AM or FM by pressing the BAND button.
2. Press the MEMORY SCAN button of the remote control
unit.
The preset channels stored in memory are scanned at 5
seconds intervals. When the station you want to listen to is
found, press the MEMORY SCAN button again to stop
scanning.
< A preset channel with no signal will be skipped.