Operating Elements And Connections; Front Panel; Rear Panel; Safety Notes - Monacor JTS US-8001D/1 Manual De Instrucciones

Diversity UHF Receiver
These instructions are intended for users without
any specific technical knowledge Please read these
instructions carefully prior to operation and keep
them for later reference
All operating elements and connections de-
scribed can be found on the fold-out page 3
1 Operating Elements
and Connections

1.1 Front panel

1 Receiving antennas
2 POWER switch
3 Power LED
4 Rotary switch* CH to adjust the transmission
channel with the adjusting key provided
5 Reception* LED RF;
lights up when a radio signal is received from
the transmitter
6 Audio signal LED* AF; lights to the rhythm of
the audio signal received
7 Volume control* VOL
* With model US-8002D / 1, these operating ele-
ments are available both for the receiver units
CH 1 and CH 2

1.2 Rear panel

8 Balanced XLR output for connection to the
microphone input, e g of a mixer or amplifier
Model US-8002D / 1 has two outputs, one for
the output signal of the receiver unit CH 1 and
one for the output signal of the receiver unit
CH 2
9 Output (6 3 mm jack, unbal ) for connection
to a highly sensitive line input, e g of a mixer
or amplifier
With model US-8002D / 1, the mixed signal from
the receiver units CH 1 and CH 2 is available
at this output
10 Strain relief for the connection cable of the
power supply unit:
Lead the cable around the hook to prevent
accidental disconnection of the plug from the
jack (11)
11 Power supply jack to connect the power supply
unit provided

2 Safety Notes

The units (receiver and power supply unit) corre-
spond to all relevant directives of the EU and are
therefore marked with
WARNING The power supply unit uses danger-
ous mains voltage Leave servicing
to skilled personnel only Inexpert
handling may result in electric
shock
•
The units are suitable for indoor use only Protect
them against dripping water and splash water,
high air humidity and heat (admissible ambient
temperature range 0 – 40 °C)
•
Do not operate the receiver or immediately dis-
connect the power supply unit from the mains
1 if the units or the mains cable are visibly dam-
aged,
2 if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3 if malfunctions occur
In any case, the units must be repaired by skilled
personnel
•
For cleaning only use a dry, soft cloth; never use
water or chemicals
•
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used
for other purposes than originally intended, if
they are not correctly connected, operated or
not repaired in an expert way
If the units are to be put out of operation
de finitively, take them to a local recycling
plant for a disposal which is not harmful
to the environment

2.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare that
the receivers US-8001D / 1 and US-8002D / 1 comply
with the directive 2014 / 53 / EU The EU declarations
of conformity are available on the Internet:
www jts-europe com
The receivers are generally approved for operation
in EU and EFTA countries; they are licence-free
and require no registration.
7