EGO Power+ LM2020SP Manual De Operaciones página 31

REPLACING THE WHEELS (Fig. 32a, 32b & 32c)
WARNING: Always remove the battery pack when servicing
or transporting the mower.
1. Turn the mower on its side with the upper surface against
a wall.
2. Use a flat blade screwdriver to pry the dust cover away
from the wheel.
3. Use an adjustable or 1/2 inch (13mm) wrench to turn the
bolt counterclockwise to loosen it.
4. Remove the bolt, the worn wheel and the washer(s) from
the wheel axle.
NOTICE: When replacing the rear wheel for the self propelled
mower (LM2020SP), remove the drive gear from the worn wheel
and assemble it to the new wheel with the 3 screws.
5. Mount the washers and the new wheel on the wheel axle.
Note that the round recess must face outward.
6. Lock the wheel with the bolt by tightening the bolt clockwise.
7. Mount the dust cover onto the wheel and press it in place.
32b
Rear wheel for LM2020SP
32a
Front wheel for both LM2020 & LM2020SP
32c
Dust Cover
Bolt
Round Recess
facing outside
Rear Wheel
Gear
Screw
Wave Washer
Wheel Axle
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2020SP/LM2020
Dust Cover
Bolt
Wave Washer
Plain Washer
Wheel Axle
Rear wheel for LM2020
Round Recess
facing outside
Front Wheel
Dust Cover
Bolt
Round Recess
facing outside
Rear Wheel
Wave Washer
Wheel Axle
31