Agri-Fab 45-02992-131 Manual Del Usuario página 5

5. Assemble a 2.38" long spacer (R), a 3/4" flat washer (M),
the middle brace, a 3/4" flat washer (M) and a 3.90" (P)
long spacer onto the long end of the shaft. The bent lip
of the middle brace must face the short end of the shaft.
Next assemble a spool assembly, a 5.29" long spacer
(S), another spool assembly, a 1.00" long spacer (Q)
and a 3/4" flat washer (M) onto the shaft. See figure 4.
MIDDLE
2.38" LONG
BRACE
SPACER (R)
3.90" LONG
SPACER (P)
3/4" FLAT
WASHER (M)
5.29" LONG
SPACER (S)
FIGURE 4
6. Rotate the wheel bracket fastened to the middle of the
shaft so that it is pointing upward. Assemble an end
plate, a 3/4" flat washer (M) and a second wheel bracket
onto the long end of the shaft. Point this wheel bracket
as shown in figure 5. Secure it to the shaft using a 1/4"
x 1-3/4" hex bolt (B) and 1/4" nylock nut (K). Tighten.
Repeat on short end of shaft.
MIDDLE WHEEL BRACKET
POINTING UP
3/4" FLAT
WASHER (M)
FIGURE 5
ENGLISH
LONG END
OF SHAFT
3/4" FLAT
WASHER (M)
1.00" LONG
SPACER (Q)
1/4" x 1-3/4"
HEX BOLT (B)
1/4" NYLOCK
NUT (K)
7. Assemble a wheel to one of the wheel brackets using
a 1/2" x 3-1/2" hex bolt (A), two 1/2" washers (O), a
1/2" jam nut (L) and a 1/2" nylock jam nut (H). Adjust
the nuts so that the wheel is held securely but will spin
freely. Repeat on other side. See figure 6.
1/2" NYLOCK
JAM NUT (H)
FIGURE 6
8. Assemble the hitch bracket to the tongue using two 3/8"
x 1" hex bolts (D) and 3/8" nylock nuts (I). Tighten. See
figure 7 .
9. Assemble the hitch pin (F) through the hitch bracket and
the tongue. Secure it with the hair cotter pin (G). See
figure 7 .
3/8" x 1"
HITCH
HEX BOLT (D)
PIN (F)
HAIR COTTER PIN (G)
FIGURE 7
5
1/2" WASHER (O)
1/2"JAM
NUT (L)
1/2" 1/2" x 3-1/2"
HEX BOLT (A)
WASHER (O)
3/8" NYLOCK NUT (I)