Storage; Troubleshooting; Technical Data - Silvercrest SKV 1200 A1 Instrucciones De Uso

■ After cleaning, reassemble the blender:
–
Push the sealing ring B back into the recess
on the blade holder A with the blade z .
–
Place the blade holder A with the blade z
back into the blender jug C so that the
blade z protrudes into the blender jug C .
–
Insert the blender tool p into the underside
of the blender t/ the blade holder A so
that the two catches on the underside of the
blender t/ the blade holder A grip into
the recesses in the blender tool p .
–
Turn the blender tool p towards
wise), so that the blade holder A with the
blade z sits hand­tight on the blender jug C .
In most cases, you can achieve sufficiently hygienic
cleaning of the blender t immediately after use in
the following way:
1) Put some water containing a little detergent
into the fully assembled blender t .
2) Place the blender lid r with measuring cup e
in position so that the lips of the blender lid r
also seal the spout .
3) Switch on the blender t for a few seconds .
4) Pour out the washing water . Any residues can
be removed with a washing­up brush .
5) Then rinse out the blender t with plenty of
clean water so that all detergent residues are
removed .

Storage

■ Store the cleaned appliance in a clean, dust­free
and dry location .
■ 66 │ GB │ MT

Troubleshooting

If the appliance suddenly stops working:
■ The appliance has overheated and triggered the
automatic safety cut­out .
–
Turn the rotary switch 3 to 0 .
–
Remove the plug from the wall socket .
–
Allow the appliance to cool for 15 minutes .
–
If the appliance has not yet cooled off com­
pletely after 15 minutes, it will not start .
–
Wait a further 15 minutes and try switching
(clock­
on again .
If the appliance cannot be switched on:
–
Check that the plug is correctly connected
to a wall socket .
–
Check whether the swivel arm 1 is in the
wcorrect position .

Technical data

Supply voltage:
Power consumption:
CO times:
Max . capacity
Mixing bowl 6:
Blender t:
All parts of this appliance that come into
contact with food are food­safe .
We recommend the following operating times:
When working with the kneading hook 0, whisk q
or beater w, allow the appliance to cool down
after 10 minutes of operation .
When working with the blender t, allow the ap­
pliance to cool down after 3 minutes of operation .
If you exceed these operating times, the appliance
can overheat and be damaged!
220 ­ 240 V ~
50/60 Hz
1200 W
Food processor 10 min .
Blender 3 min .
approx . 6 .0 l
approx . 1 .5 l
SKV 1200 A1