Cleaning And Servicing The Device; Cleaning The Base Unit; Cleaning In The Dishwasher; Rinsing By Hand - Silvercrest SKMM 1000 A1 Instrucciones De Servicio

mini crusher slightly in a clockwise direction until it is
heard to lock into place.
6. Connect the mains plug 11 to a wall socket.
7. Use the dial 13 to select the desired speed setting.
8. When the process is completed, switch the dial 13 to
0 and pull out the mains plug 11.
9. Turn the mini crusher slightly anticlockwise and re-
move it.
10. Turn the blade unit 16 clockwise and remove it
from the mini container 17.
11. Ingredients which stick to the blade unit 16 can be
carefully removed with a small dough scraper or sim-
ilar device.
12. Remove the crushed ingredients from the mini con-
tainer 17.
13. Clean all of the accessories that have been used im-
mediately if possible.
15. Cleaning and servicing the
device
DANGER! Risk of electric shock!
Disconnect the mains plug 11 from the wall socket be-
fore any cleaning.
Never immerse the base unit 14 in water.
DANGER! Risk of injury from cutting!
Please remember that the blades of the disc 7 + 6 + 5,
the blade assembly 9 and the blade unit 16 are very
sharp. Never touch the blades with your bare hands in
order to avoid cuts.
CAUTION:
Never use any abrasive, corrosive or scouring clean-
ing agents. These might damage the device.
NOTE: certain foods or spices (e.g. curry) may discolour
the plastic. This is not a defect with the device and is harm-
less to health.

15.1 Cleaning the base unit

1. Clean the base unit 14 with a damp cloth. You can
also use a little washing-up liquid.
2. Then wipe off with a clean, moist, light cloth with
clean water.
3. Do not use the base unit 14 until it is completely dry
again.

15.2 Cleaning in the dishwasher

The following parts are dishwasher-safe:
- Working container 10
- Lid 4
- Axle 18
- Blade assembly 9
- Mixer assembly 20
- Whisking disc 8
- Small juicer cone 21
- Large juicer cone 22
- Screen 19
- French fries disc 7
- Coarse grater and cutting disc 5
- Fine grater and cutting disc 6
- Mini container (for the mini crusher) 17
- Mini food pusher 1
- Midi food pusher 2
- Maxi food pusher 3
The following parts must never be cleaned in a dishwash-
er:
- Base unit 14
- Blade unit (for the mini crusher) 16

15.3 Rinsing by hand

DANGER! Risk of injury from cutting!
When rinsing by hand, use water which is so clear
that you are able to see the blades of the discs 7 + 6
+ 5 of the blade assembly 9 and the blade unit 16
properly in order to ensure that you do not injure your-
self on the very sharp blades.
All accessories except for the base unit 14 can also be
cleaned by hand.
• If possible, clean all accessories immediately after use.
• Use rinsing water with mild washing-up liquid and
rinse off all parts with clean water.
• Allow the parts to dry completely before using them
again or clearing them away.

15.4 Storage

Store the device so that it is protected against dust and dirt
and out of the reach of children.
73
GB