3 Settings Via The Menu; 4 Basic Settings And Reset - Monacor JTS R-4/5 Manual De Instrucciones

2) The display can show the following informa-
tion:
Indica-
Meaning
tion
left side of the display
Key lock activated
Operating voltage for antenna ampli-
fiers connected is switched on
The output MIXED AF OUTPUT (18)
AT
is set to microphone level
separately for each of the four receiver sections
3
Number of the receiver section (1 – 4)
The signal output CH
AT
microphone level
Indication which of the two anten-
nas (A or B) receives the radio signal
A
of higher strength; when no signal is
received, × will be shown
Identification number for the
ID
REMOSET function
Group number (1 ... 6)
G
Channel number (1 ... 22)
CH
Transmission frequency
MHz
(506 000 ... 542 000 MHz)
Status of the batteries of the trans-
mitter
– when no signal is received or when
– as long as the battery status has
The output level adjusted by means of
the buttons
Fig. 5 Display information
3) Use the buttons
the volume of the four microphone signals
These volumes will also be used when the
signals are routed to the output MIXED AF
OUTPUT (18)
4) The receiver is provided with a key lock to pre-
vent inadvertent switch-off or operation: Keep
the button
the symbol
display To deactivate the key lock, keep the
button pressed for 2 seconds until the symbol
disappears
20
(19) is set to
the transmitter is muted, the mes-
sage will be shown instead
MUTE
of the battery symbol
not been transferred yet, a ques-
tion mark will be shown
: ,
  Mute
(13) to separately adjust
 
(9) pressed for 1 second until
appears on the left side of the
5) To switch off the receiver, keep the button
pressed for 2 seconds until
shown on the display

4.3 Settings via the menu

1) To call up the menu (fig 2, page 17), keep the
button SETUP (6) pressed for 2 seconds until
the menu appears on the display (3)
2) Turn the knob PUSH / CONTROL (7) to select
the desired menu item Then press the knob
to call up the menu item
3) Turn the knob to make the setting or, when a
submenu appears, turn the knob to select a
submenu item and press the knob to call it up
4) If multiple setup functions are available for a
menu item (e g group number and channel
number), press the knob to go from one func-
tion to the next one
5) To save a setting, press the button SETUP The
display briefly indicates
previous menu reappears
press the button EXIT (8)
6) To exit the menu, press the button EXIT or
select the menu item
the knob PUSH / CONTROL
All setting options via the menu can be found in
the following chapters

4.4 Basic settings and reset

1) If it is difficult to read the display, change the
contrast and the brightness.
Call up the following menu via
Options
...
-31 0
Contrast:
Brightness: 5
Turn the knob PUSH / CONTROL to set the
contrast Press the knob to go to
ness
button SETUP to save the setting The previous
menu will reappear
EXIT twice or to change another setting, turn
the knob PUSH / CONTROL to select the cor-
responding menu item and press the knob
to call it up
To exit a menu item without any changes,
7.Exit

1.Display Options
Screen Options
5
and then set the brightness Press the
To deactivate the menu, press the button
is
Power OFF
before the
Saving
and then press
1.System
:
Fig. 6
Bright-