Features; Assembly; Operation - Ryobi P411 Manual Del Operador

PRODUCT SPECIFICATIONS
Sanding Disc Size ............................................................................................................................................................5 in.
Orbit Diameter ............................................................................................................................................................ 3/32 in.
No Load Speed ................................................................................................................... 10,000 OPM (Orbits Per Minute)
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.

FEATURES

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.

OPERATION

APPLICATIONS
You may use this product for the purposes listed below:
 Sanding on wood surfaces
 Removing rust from and sanding steel surfaces
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be in the OFF
position when not in use or carrying at your side.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 9.
To install:
 Insert the battery pack.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
To remove:
 Depress the latches on each side of the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
TURNING THE SANDER ON/OFF
See Figure 2, page 9.
 To turn the sander ON or OFF: push the ON/OFF switch
in the direction shown.
5 — English