B+B Neo XXL Manual De Instrucciones página 31

Neo XXL
| Electric Wheelchair
16
17
Battery Status Display
The battery status display shows to what extent the batteries are
charged (fig 17). If the indicator is within the green range, you have
enough battery power available. If the indicator is within the red range,
only short drives are possible and the batteries should be recharged.
(See charging procedure)
ON/OFF Button
18
Pushing this button will put your wheelchair into operational mode
(fig 18).
Speed Range Display
The speed range display shows you the pre-selected speed range.
You can set the speed between level 1 and 5, with the corresponding
number of LEDs lighting up (fig 19). The speed range indirectly tells
you the maximum speed possible at full deflection of the joystick, i.e.
19
with level 5 you can reach the maximum speed possible, while level 1
will keep you within the lowest speed range.
60
Electric Wheelchair |
Setting the Speed Range
These buttons (fig 20) allow you to increase (right) or decrease (left)
the maximum speed possible. Within each range you control the speed
with the joystick.
Light
Use this button to switch on the active lighting system of your
wheelchair when darkness falls or when travelling through
dark areas such as tunnels. This will make you more visible to
other traffic (fig. 21).
Warning indicators
Press this button to switch on the warning indicators in emergency
situations, such as inability to move the wheelchair. All four indicator
lights will flash and signal other traffic that your wheelchair is disabled
(fig. 22).
Indicators (left/right)
Use this button (fig. 18) to switch on the left or right indicators of
your wheelchair to signal other traffic that you wish to change your
direction of travel to the left or right. Press the button again to switch
off the indicators.
Immobiliser
To protect your wheelchair from unauthorised use or theft store it in a
locked room or activate the immobiliser.
• Press and hold the On/Off button until you hear a beep and
release it.
• Move the joystick in the direction of travel and then to the neutral
position. It will beep in each position. Now the control is locked.
• Switch on the controller with the On/Off button.
• Move the joystick in the direction of travel and then to the neutral
position. It will beep in each position. Now the control is released.
Bischoff & Bischoff GmbH | 01.06.2019
Neo XXL
20
21
22
23
61