Melita Caffeo SOLO & perfect milk Serie Manual De Instrucciones página 21

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 56
• Press the ON/OFF button
the appliance on or off. If necessary, the
appliance performs an automatic rinse.
Preparation
• Fill the water reservoir with fresh water
every day. The water reservoir must
always be fi lled with enough water for
the operation of the appliance.
• Fill the bean container preferably with
espresso beans or bean mixtures for
fully automatic coffee machines.
Do not use any glazed, caramelised or
otherwise sugar-coated coffee beans.
Setting the dispensed quantity and
strength
• Turn the coffee quantity regulator 4 to
infi nitely adjust the dispensed quantity.
Regulator all the way to the left = 30 ml
per cup
Regulator all the way to the right = 220
ml per cup
• Press the
button until the desired
strength is adjusted. The strength is
shown by the beans on the display 10
(from
= mild to
Dispensing coffee or espresso
One or two cups can be dispensed
simultaneously.
• Switch on the appliance.
• Place one or two cups under the outlet.
• Preparing one cup: Press the
button once
• Preparing two cups: Press the
button twice.
• Press the button again to cancel the
coffee dispensing.
BA_Solo_Perfect_Milk_042015.indd 21
BA_Solo_Perfect_Milk_042015.indd 21
Preparing milk froth and heating
to switch
milk and water
Warning!
There is a risk of burn injuries and
scalding due hot steam and the hot
steam pipe.
– Never reach into the escaping steam.
– Avoid direct skin contact with hot water
and the hot steam pipe.
– Never touch the steam pipe during
use or immediately after use.
The Cappuccinatore is used to prepare
milk froth, to heat milk or to dispense hot
water.
It can froth the milk directly from the milk
carton or a vessel into the cup.
Preparing milk froth
If possible, use cold milk with a high
protein content.
• Switch on the appliance.
• Submerse the Cappuccinatore hose 13
directly into the milk.
• Press the
= strong).
the appliance is heating up. After the
heat-up phase,
• Turn the control dial (Image F, 3) to the
"Milk froth" position (
• Turn the valve switch 11 clockwise until
the stop.
being prepared.
• Turn the valve switch 11
counterclockwise until the stop. The
preparation is fi nished.
• Rinse the Cappuccinatore after each
use.
button.
fl ashes while
is illuminated.
is pointing up).
is fl ashing. The milk froth is
20.04.2015 21:17:14
20.04.2015 21:17:14
21

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Caffeo solo & perfect milk

Tabla de contenido