Setting The Water Hardness - Melita Caffeo SOLO & perfect milk Serie Manual De Instrucciones

• Press and hold the
for approx. 3 seconds, then release.
appears on the display.
• Empty the drip tray and insert without
the coffee grounds container.
illuminates.
• Pull the water reservoir 7 up and out of
the appliance.
• Empty the water reservoir.
• Screw the water fi lter onto the thread at
the bottom of the water reservoir.
• Fill the water reservoir with fresh tap
water up to the max. mark.
• Insert the water reservoir into the
appliance. illuminates.
• Place the coffee grounds container
under the Cappuccinatore 13.
• Turn the valve switch 11 clockwise until
the stop. fl ashes on the display.
Water will fl ow into the vessel.
• When is illuminated on the
display, turn the valve switch 11
counterclockwise until the stop.
• The appliance is ready for operation.
and illuminate. The water hardness
is automatically set to hardness level 1.
• Empty and insert the coffee grounds
container.
After inserting the water fi lter, the water
can be cloudy during the fi rst rinse
because excess activated carbon is
washed out of the fi lter. The water will then
be clear clear again.
BA_Solo_Perfect_Milk_042015.indd 23 BA_Solo_Perfect_Milk_042015.indd 23

Setting the water hardness

and buttons
The appliance includes a test strip to
determine the water hardness.
• Determine the hardness of the tap water
using the test strip.
• Switch on the appliance.
• Press the
simultaneously for longer than 2
seconds.
• Press the
menu for setting the water hardness.
illuminates.
• Set the determined water hardness by
pressing the
water hardness is shown by the bean
symbols
4:
• Press
and
fl ashes rapidly.
button to show the
button. The selected
.
Water hardness °d
0 - 1 0
1:
10 - 1 5 13 - 1 9 18-27
2:
15 - 2 0 19 - 2 5 27-36
3:
> 20
fl ashing
to confi rm the selection.
buttons
°e °f
0 - 1 3 0 - 1 8
> 25 > 36
23
20.04.2015 21:17:14 20.04.2015 21:17:14