Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

REMOVING CUTTING WHEEL
See Figure 3, page 13.
 Remove the battery pack from the tool.
 Remove the 4 mm hex key from the storage area.
 Loosen the knob on the back of the wheel guard and slide
the shoe assembly to its lowest position.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1 along with hearing protection,
dust mask (in dusty conditions) and where necessary a
full face shield. Failure to do so could result in objects
being thrown into your eyes and other possible serious
injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purpose listed below:
 Cutting drywall, plastic, tile, ceramics, steel, stainless
steel, fiber cement, and non-ferrous materials
NOTE: Applications for this tool require different types of
cutting wheels. Be sure to use the right cutting wheel for
the job you are attempting.
INSTALLING/REMOVING BATTERY PACK
See Figure 4, page 14.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
ASSEMBLY
 Position the tool as shown, depress the spindle lock
button, and remove the wheel screw by turning it coun-
terclockwise.
 Remove the outer wheel washer.
 Remove the wheel.

OPERATION

OVERLOAD PROTECTION
When the tool is forced or the motor is overloaded, the tool
will automatically shut off. To reset the tool, release the trigger
and resume operation. If the tool still does not resume opera-
tion, remove and reinsert the battery. Do not force the tool.
VARIABLE SPEED SWITCH TRIGGER
See Figure 5, page 14.
WARNING:
Always check that the spindle lock button is fully released
before switching on the tool.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the tool ON, depress the switch trigger. To turn it
OFF, release the switch trigger and allow the wheel to come
to a complete stop.
NOTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
NOTE: Running at low speeds under constant usage may
cause the tool to become overheated. If this occurs, cool the
tool by running it without a load and at full speed.
NOTICE:
Never cover air vents when the tool is in use. They must
always be open for proper motor cooling.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
See Figures 5 and 6, page 14.
Set the direction of rotation selector in the OFF (center lock)
position to lock the switch trigger and help prevent accidental
starting when not in use.
Position the direction of rotation selector to the left of the
switch trigger for forward wheel rotation. Position the selec-
tor to the right of the switch trigger to reverse the direction.
NOTE: The tool will not run unless the direction of rotation
selector is pushed fully to the left or right.
9 - English

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Psbcs02b

Tabla de contenido