Assembly; Operation - Ryobi PBLRT01 Manual Del Operador

Herramienta giratoria sin escobillas de 18 v
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to
the product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you
are assembling parts, making adjustments, changing
accessories, cleaning, or when not in use. Removing
battery pack will prevent accidental starting that could
cause serious personal injury.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
CONNECTING THE PEN HOLDER AND FLEX
SHAFT TO THE ROTARY TOOL CONSOLE
See Figure 1, page 14.
The pen holder can be assembled on the left or right,
depending on the user's preference.
 Slide the flange on the pen holder into the opening on
the side of the rotary tool console until it is fully seated.
NOTE: Once fully seated, the tab on the flange will snap
into the housing, preventing the pen holder from being
removed.
 Place the collar of the flex shaft onto the threaded outlet
on the rotary tool console.
 Turn the collar clockwise and tighten securely.

OPERATION

WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Hearing protection may also
be required depending on the type of attachment used
and as prescribed elsewhere in this Operator's Manual.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
8 — English

Publicidad

Tabla de contenido
loading

Tabla de contenido