Telcoma T201 Manual De Instrucciones página 63

GB
DECELARATION TIME PROGRAMMING
If you wish to have decelerations values different from the factory settings, you must execute the time learning stage with
dip-switch n. 9 (det. 14 fig. 1) set to ON.
During the learning stage you must press button P/P (det. 20 fig 1) at the point where you wish the deceleration to start,
before the wing reaches the end-of-travel position.
PROGRAMMING OF PEDESTRIAN OPENING (only for automations with one motor, dip-switch 11 to OFF)
1
7
1 and 2 - When the gate is in mid-travel position, disconnect the power supply to the control unit.
3 - Press the STOP/PROG. button (det. 21fig. 1).
4, 5 and 6 - Power the control unit while holding down the STOP/PROG. button for at least 3 seconds. Programming Led L1 will
light up (det. 8 fig. 1). The same function can be obtained by pressing and holding down the STOP/PROG. button, momentarily
short-circuiting the reset pins (det. 15 fig. 1), and then releasing the STOP/PROG. button when Led L1 lights up.
7 - Activate the pedestrian control. The gate will close.
8 - When the gate strikes the closing stop, activate the pedestrian control again if there are no limit switches or encoder or MAS200.
9 - The gate will start opening.
10 - When the desired pedestrian opening position is reached, activate the pedestrian control. The gate will stop and start closing again.
11 - When the gate strikes the closing stop, activate the pedestrian control again if there are no limit switches or encoder or MAS200.
12 - The motor will stop and Led L1 will go out.
INDEPENDENT PAUSE TIME PROGRAMMING
This procedure allows you to modify the pause time without having to completely re-.program the control unit.
1 - With the gate closed disconnect the power supply to the control unit.
2 - Press the STOP/PROG. button (det. 21 fig. 1).
3, 4 and 5 - Power the control unit while holding down the STOP/PROG. button for at least 3 seconds. Programming Led
L1 will light up (det. 8 fig. 1).
2
3
9
8
PED PED
4 5
10
11
PED PED
6
12
63