Instructions For Use; Control Panel Description - Bauknecht Domino 300 Instrucciones De Uso

41902039.book Page 13 Monday, September 26, 2011 4:53 PM
Connect the yellow/green earth wire to the terminal with the symbol
This wire must be longer than the other wires.
1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).
2. Insert the power cable in the cable clamp and connect the wires to the terminal block as indicated in the connection diagram located near it.
3. Secure the power cable with the cable clamp.
4. Close the cover (C) and screw it on the terminal block with the previously removed screw.
Each time the power is connected, the hob performs an automatic check for a few seconds.
If the hob already has a power cable, follow the instructions attached to the cable. Connect the appliance to the power supply by means of a multipole switch with
minimum contact gap of 3mm.

INSTRUCTIONS FOR USE

Control Panel Description

Control panel
On/Off
Cooking zone controls and corresponding display
Switching the hob ON/OFF
To switch the hob on, press the button for approx. 2 seconds until the cooking zone displays light up. To switch off, press the same button until the displays switch
off. All the cooking zones are deactivated
If the hob has been in use, the residual heat indicator "H" remains lit until the cooking zones have cooled down.
If within 10 seconds of switching on, no function is selected, the hob switches off automatically.
Switching on and adjusting cooking zones
Button -
Cooking zone positioning
After switching the hob on and placing the pot on the chosen cooking zone, adjust the power level using the + button. Upon activation, the display shows level 5.
Each cooking zone has various power levels, adjustable with the +/- buttons, going from "1": min. power, to "9": max. power. Some cooking zones have a fast boil
function (Booster), shown on the display with the letter "P".
Fast boil function (Booster)
This function, only present on some cooking zones, makes it possible to exploit the hob's maximum power (for example to bring water to the boil very quickly). To select this
function, press the button "+" until "P" appears on the display or, after switching the hob on, press the "-" button for the selected cooking zone. In this case too, "P" appears
on the display. After 10 minutes' use of the booster function, the appliance automatically sets the zone to level 9.
Deactivation of cooking zones
Select the cooking zone to be switched off by pressing the "+" or "-" key (a dot lights up at the bottom right hand side of the heat setting indicator).
Press the key "-" to set the level to "0".
The cooking zone can also be switched off by pressing the "+" and "-" buttons at the same time. The cooking zone switches off and the residual heat indicator "H" lights
up.
Control panel lock
This function locks the hob controls to prevent accidental switching on. To activate the control panel lock function, switch on the hob and hold button
acoustic signal and a luminous indicator above the key signal activation. The control panel is locked except for the deactivation function. To deactivate the control panel lock, repeat
the activation procedure. The luminous dot goes off and the hob is active again.
The presence of cleaning water, liquid spilled from pots or any objects resting on the button below the symbol can accidentally activate or deactivate the control panel
lock function.
.
Timer
Key lock
Heat setting indicator
Button +
Selected cooking zone indicator
GB13
the symbols are not active!
To select the desired
functions, touch the
areas below.
for three seconds; an