Using The Appliance For The First Time; Daily Use - Bauknecht HVS5 TH8VS3 ES Guía Rápida

Quick guide

USING THE APPLIANCE FOR THE FIRST TIME

1.
SETTING THE TIME
You will need to set the time when you switch on the
appliance for the first time: "AUTO" and "0.00" flash on
the display.
A
U
T
O
To set the time of day, press buttons
same time: Set the time of day using the
buttons.
Please note: To change the time of the day afterwards for
example following lengthy power outages, you will need to
reset the time.
2.
SETTING THE TONE
Having selected the desired time value, press the time
button: The display shows "ton 1".
A
U
T
O
To select the desired tone, press button
the time button to confirm.

DAILY USE

1.
SELECT A FUNCTION
To select a function, turn the selection knob to the
symbol for the function you require.
2.
ACTIVATE A FUNCTION
To start the function you have selected, turn the
thermostat knob to set the temperature you require.
To interrupt the function at any time, switch off the
oven, turn the selection knob and the thermostat knob
to and .
3.
PREHEATING
Once the function has been activated, the LED
thermostat will switch on signalling that the
preheating process has begun.
At the end of this process, the LED thermostat
switches off indicating that the oven has reached the
set temperature: at this point, place the food inside
and proceed with cooking.
Please note: Placing the food in the oven before preheating
has finished may have an adverse effect on the final cooking
result.
3.
HEAT THE OVEN
A new oven may release odours that have been left
behind during manufacturing: this is completely
normal. Before starting to cook food, we therefore
recommend heating the oven with it empty in order
to remove any possible odours.
Remove any protective cardboard or transparent
film from the oven and remove any accessories from
inside it. Heat the oven to 250 °C for about one hour,
preferably using the "Convection Bake" function. The
and at the
oven must be empty during this time.
and
Follow the instructions for setting the function
correctly.
Please note: It is advisable to air the room after using the
appliance for the first time.
, then press
.USING THE ELECTRONIC PROGRAMMER
1. Button – : to decrease the value shown on the display
2. Button
a. Timer
b. Cooking time
c. Cooking end time setting
3. Button +: to increase the value shown on the display
A. The symbol
B. The AUTO symbol confirms the setting has been made
Using the oven for the first time
Setting the time of day and the tone of the acoustic signal. Upon
connection of the oven to the mains power supply, AUTO and 0.00 flash
on the display. To set the time of day, press buttons – and + at the same
time: the central dot flashes. Set the time of day using the buttons +
and –. Having selected the desired value, press the middle button. The
display shows "ton 1". To select the desired tone, press button –. Having
selected the preferred tone, press the middle button. To change the
time of day, proceed as described above.
: for selecting the various settings:
indicates that the timer function is in operation
A
U
T
O
1 2 3
EN
B
A