Safety Notes; Applications; Installation - IMG STAGELINE PARL-12RGBW Manual De Instrucciones

2

Safety Notes

The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The power supply unit uses danger-
ous mains voltage. Leave servicing
to skilled personnel and do not insert
anything into the air vents! Inexpert
handling or modification may result
in electric shock.
Please observe the following items in any case:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity and heat (admissible ambient tempera-
ture range: 0 – 40 °C).
G
Do not place any vessel with liquid on the unit,
e. g. a drinking glass.
G
The heat generated inside the unit must be dissi-
pated by air circulation; never cover the air vents
of the housing.
G
Do not operate the unit and immediately discon-
nect the mains plug unit from the socket
1. if the unit or the mains cable is visibly dam-
aged,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by skilled
personnel.
G
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
safely installed, if it is not correctly connected or
operated, or if it is not repaired in an expert way.
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.
3

Applications

The LED spotlight PARL-12RGBW can be used to
. create effect illumination, e. g. on stage, in dis-
cotheques or in ballrooms. The spotlight features
12 super-bright 8 W RGBW LEDs as a light source.
The LEDs can emit light in the three primary
colours (red, green and blue) and in white as well
as coloured light created from additive colour mix-
ing. Crossfading from one colour to another and
stroboscope effects are also supported.
The spotlight is designed for control by means of
a DMX light controller (1, 4, 5 or 8 DMX channels
available), but may also be operated on its own or
in combination with multiple spotlights PARL-
12RGBW (master /slave mode). The spotlight can
be conveniently controlled by means of the infrared
remote control supplied. In addition, the integrated
microphone provides effects in sync with the music.
4

Installation

When placing the unit, make sure that sufficient air
circulation is provided during operation. Never
cover the air vents of the housing.
WARNING Install the spotlight safely and
1. Use a mounting bracket (3) to fasten the spot-
light, e. g. by means of a stable mounting screw
or a support for lighting units (C hook) on a
crossbar.
To align the spotlight, loosen the two set -
screws (5) on the mounting bracket. Tilt the spot-
light as desired and then firmly retighten the
setscrews.
2. Alternatively, set up the spotlight on its own: Fold
out the mounting brackets underneath the spot-
light and use them as stands. Then firmly tighten
the setscrews.
expertly. When installing the spot-
light at a place where people may
walk or sit under it, additionally
secure it (e. g. by means of a safety
rope on the mounting bracket; fasten
the safety rope in such a way that the
maximum falling distance of the
spotlight will not exceed 20 cm).
GB
13