Victor PL8000 Manual De Instrucciones página 11

28. [+ / OK] Addition / OK Key
+ Adds an amount to the Accumulator. To add the same amount more
than one time (repeat addition), enter that amount once and depress the
Plus key as many times as necessary. If this key is depressed
immediately after [%] key, it works as percent plus key.
OK Under PROG mode or TEXT mode, this key work as OK key, for confirm
the selection.
29. [GT / Text 1] Grand Total / Text 1 Key
GT Print and clear the Grand Total Memory or Total Sigma.
Text 1 Under Text Mode, use this key to print or save Text 1.
30. [#/S / Text 2] Date / Subtotal / Text 2 Key
#
Print live entry as an identifier, like an invoice number, with "#" mark.
S Prints but does not clear the accumulator.
Text 2 Under Text Mode, use this key to print or save Text 2.
31. [T / Text 3] Total / Text 3 Key
T
Prints and clears the accumulator.
Text 3 Under Text Mode, use this key to print or save Text 3.
32. [MT / Amount / Start Date]
Memory Total / Amount / Start Date Key
MT
Prints and clears the memory.
Amount Under Loan Mode, press this key to carry out the Calculation of Loan
Amount.
*Refer to Page 29 for detail operation.
Start Date Under Date Calculation Mode, press this key to enter Start Date.
* Entry format : MM-DD-YYYY
* Refer to Page 28 for detail operation.
33. [M− / Interest / End Date]
Memory Subtraction / Interest / End Date Key
M− Subtracts an amount from memory. If there is a live calculation pending,
the Memory Minus key will complete the calculation and subtract the
amount from Memory.
Interest Under Loan Mode, press this key to carry out the Calculation of Loan
Interest.
End Date Under Date Calculation, press this key to enter End Date.
* Entry format : MM-DD-YYYY
* Refer to Page 28 for detail operation.
- 11 -