Electrical Wiring - Bornay 600 Manual De Usuario

 CAUTION:
The wind turbine must be able to
turn 360º freely with no obstacles
in its way.

Electrical wiring

Full electrical wiring installation must be carried out prior to the installation of
the wind turbine and once the tower has been installed.
 CAUTION:
Never install the wind turbine
if the regulator and batteries
are not properly connected.
Any object touching the blades
in movement, will break them
and will unbalance the system
causing major problems.
Once the wind turbine has been installed on
the tower, check that it can turn freely and
that there are no obstacles within the
diameter of the blades.
Under wind pressure, the blades can have up
to 15cm of torsion, so there must be a
minimum distance of 20cm between the
blades and the nearest point.
Bornay 600 – Rev 6.0 - P 46
 WARNING:
 WARNING:
Any object
contact with the moving
blades can damage and
unbalance them.
 WARNING:
Never invert polarity.
Use appropriate sized cables.
making