Bornay 600 Manual De Usuario página 57

well as the interconnection between batteries and regulator.
Once we have the electrical wiring installed,
we will proceed to assemble the wind
turbine.
To ease installation of the wind turbine on
the tower, a bracket and pulley system
should be used.
This system must securely attach to the
tower, with the pulley on top.
Using this method, the turbine can be
hoisted up and secured while the electrical
connection is completed and the turbine is
fitted to the tower.
Fixation plate
This plate is provided to be attached to the tower. Another one is assembled on
the wind turbine base.
Its function is to secure wind turbine, offering an ease of installation and
removal from the tower at any moment.
The plates are made with slots to allow the cables to pass through without
twists. They are attached with Allen bolts and six holes are provided for six M -
10 x 40 Allen bolts, with M -10 washers on both faces and six M -10 nuts. The
bolts set and tower plate are served in an independent plastic bag, if not mailed
before.
Bornay 600 – Rev 6.0 - P 57