Bornay 600 Manual De Usuario página 65

Keep in mind that there is a margin of error of several Amps, so if the
charge is low, say 1 or 2 Amps, the screen may display 0 (zero).
9.- ¿Could the drilled holes in the blades be bad?
No, each wind turbine is assembled completely in production. If the drilled
holes do not match up, try turning the blades round the other way. Some
models have 3 and some have 5 holes drilled, and one of these is slightly
off centre in order to define correct blade installation.
10.- ¿Will one of these wind turbines provide enough power for a home?
This kind of wind turbine is normally used together with other
components to form a complete installation. These components are
usually:
Solar panels: energy production.
Solar regulators: to control battery charge from the solar panels.
Batteries (accumulation of this energy):
normally designed to give three full days of independence, in
other words they can supply the installation for three days
without sun or wind. They use direct current.
Wind regulator:
controls battery life. It ensures that battery voltage does not
surpass dangerous levels.
machinery when this does occur.
Inverter/Charger:
from batteries into alternating current for consumption (230V).
Back-up generator: In remote installations, this is installed to guarantee
complete independent functioning of the installation. Normally,
the inverter handles the start-up and stopping on the motor
according to installation needs. For example, if the battery runs
the inverter will order the motor to start.
11.- ¿Can several wind turbines be set up in parallel?
Yes, several wind turbines can be run in parallel.
This is included with the wind turbine and this is what
This is the equipment that transforms direct current
Bornay 600 – Rev 6.0 - P 65
These installations
At the same time, it will brake the
are