Schneider Airsystems FSP-W 400 - 1,3 Manual De Instrucciones página 30

GB
FSP
Problem
E Material accumula-
tion concentrated in
the middle
F Spray pattern
moved to one side
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
If necessary, contact our service staff, see last page.
II/ 12
Cause
Too much material application
Working pressure (flow pres-
sure) too low
Viscosity is too high
Dirty or deformed holes on the
flanges of the air cap
Remedy
X
Use smaller nozzle set Reduce
paint quantity (item 03):
Decrease material
(item 18):
X
Increase working pressure (flow
pressure) Observe
working pressure
X
Decrease viscosity or increase
material pressure (item 18)
X
Clean (see Chapter 4, 5) or re-
place complete
(item 10, 11, 12
Figure 3a-c)
pressure
maximum
*
nozzle set
or 13) (see