5.4
Changing the star knobs on the lap‐
top/tablet holder
Change the star knobs.
1
(1) Star knobs
---Separator---
5.5
Changing the knurled-head screws on
the laptop/tablet holder
Change the knurled-head screws.
1
(1) Knurled-head screws
---Separator---
5.6
Changing the pointer on the align‐
ment aid
(4)
A spacer
is located between the pointer
and the rectangular bar.
(2)
1. Slide the pointer
to the round opening
rectangular bar.
2. Remove the star knob (3).
(1)
3. Remove the screw
through the round opening
(5).
4. Remove the pointer (2).
Robert Bosch GmbH
1 1
(1) Screw
(2) Pointer
(3) Star knob
(4) Spacer
(5) Round opening in rectangular bar
(6) Guide
5. Position the spacer at the height of the round open‐
ing.
6. Carefully slide the new pointer through the guide at
the height of the round opening.
7. Make sure the point is positioned on the spacer in
such a way that the screw can be guided through.
8. Slide the screw through the round opening, the
pointer and the spacer.
9. Attach the star knob to the protruding screw.
---Separator---
5.7
Changing the feet on the base plate
(2)
of the alignment aid
1. Carefully slide the pin
top to bottom.
(5)
in the
(1) Foot
(2) Pin
2. Pull out the foot toward the bottom.
3. Insert the new foot.
4. Fully slide the pin into the foot from bottom to top.
The foot is now securely attached to the base
plate.
---Separator---
SCT 17 | 15 | en
5
6
(2)
out of the foot
4712004-21_shd
1
2
1 689 989 391 | 2018-08-01
4
3 3
2 2
(1)
from