en | 14 | SCT 17
6. Align the vertical line in the camera image with two
centrally located reference points on the vehicle, for
example the manufacturer's badge on the front of
the vehicle and the antenna on the roof of the vehi‐
cle.
The adjustment device is now centrally aligned
with the front of the vehicle.
The adjustment device is now positioned in front
of the vehicle according to the vehicle-specific
specifications.
7. Attach the vehicle-specific calibration board to the
adjustment device.
8. Use ESI[tronic] 2.0 to start the front camera calibra‐
tion.
---Separator---
5.
Maintenance
5.1
---Separator---
Cleaning
Coarse workshop rags and abrasive cleaning
agents may damage the SCT 17 .
Use only neutral cleaning agents and soft cloths to
clean the SCT 17.
---Separator---
5.2
Spare parts
Denomination
<)
USB connecting cable
Holder for laptop/tablet
Star knob for laptop/tablet holder
Knurled-head screws for laptop/tablet holder
Camera bracket with mounting bracket
Clamp for camera bracket
<)
Alignment aid
<)
Pointer of alignment aid
<)
Feet of alignment aid
<)
Reference board
---Separator---
<)
Wearing parts
---Separator---
5.3
Changing the USB connecting cable
of the camera
1. Unplug the USB connecting cable from the laptop/
tablet.
2. Unscrew the camera from the camera bracket.
3. Remove the camera cover.
1 689 989 391 | 2018-08-01
Order number
1 684 465 850
1 688 005 261
1 686 621 076
<)
1 683 481 074
1 688 018 057
1 681 321 369
1 681 098 009
1 682 012 022
1 683 130 002
1 681 098 012
(1) Camera cover
(2) Screws
(3) Washers
(4) USB connecting cable
4. Remove the strain relief.
1
2
3
4
(1) Strain relief
(2) Screw
(3) Washer
(4) USB connecting cable
5. Change the USB connecting cable.
6. Secure the new USB connecting cable with the
strain relief.
7. Attach the camera cover.
8. Attach the camera to the camera bracket.
9. Plug the USB connecting cable into the laptop/
tablet.
---Separator---
1
3
2
4
Robert Bosch GmbH