Specifications - Rotel RA-12 Manual De Instrucciones

14

Specifications

Continuous Power Output
(20 - 20k Hz, < 0.03%, 8 ohms)
Total Harmonic Distortion (20 Hz - 20k Hz)
Intermodulation Distortion (60 Hz : 7k Hz, 4:1)
Frequency Response (8 ohms)
Phone input
Line Level Inputs
Damping Factor (20 - 20,000 Hz, 8 ohms)
Input Sensitivity / Impedance
Phone input
Line Level Inputs
Input Overload
Phone input
Line Level Inputs
Preamp Output / Impedance
Tone Controls - Bass / Treble
Signal to Noise Ratio (IHF "A" weighted)
Phone input
Line Level Inputs
Digital Section
Frequency Response
Signal to Noise Ratio (IHF "A" weighted)
Input Sensitivity/Impedance:
Preout/Impedance:
Decodable front USB Digital Signals:
Coaxial/Optical
General
Power Requirements
USA
EC
Standby Power Consumption
RA-11 Power Consumption
RA-11 BTU (4 ohms, 1/8th power)
RA-11 Dimensions (W, H, D)
RA-11 Panel Height
RA-11 Weight (net)
RA-12 Power Consumption
RA-12 BTU (4 ohms, 1/8th power)
RA-12 Dimensions (W, H, D)
RA-12 Panel Height
RA-12 Weight (net)
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co., Ltd.
Tokyo, Japan.
40 watts/ch (RA-11)
60 watts/ch (RA-12)
< 0.03%
< 0.03%
20 Hz - 15k Hz, ± 0.3dB
10 Hz - 100k Hz, ± 1dB
180
2.5mV / 47k Ohms
150 mV / 24k Ohms
180 mV
5 V
1 V / 470 Ohms
± 10 dB at 100 Hz / 10k Hz
80 dB
100 dB
10Hz - 95k Hz (± 3.0dB,MAX)
100 dB
0 dBfs/75 ohms
1.2 V/470 ohms (at - 20dB)
WAV, MP3, WMA
(up to 48K 16 bit)
SPDIF LPCM
(up to 192k Hz 24 bit)
120V, 60 Hz
230V, 50 Hz
< 0.5W
220 Watts
311 BTU/h
17" x 2 7 / " x 13 1 / "
8 2
430 x 72 x 342 mm
60 mm / 2 3 / ".
8
6.39 kg, 14 lbs.
300 Watts
517 BTU/h
17" x 3 5 / " x 13 1 / "
8 2
430 x 92 x 342 mm
80 mm / 3 1 / ".
16
8.02 kg, 18 lbs.
RA-12, RA-11 Stereo Integrated Amplifier
"Made for iPod," and "Made for iPhone," means that an electronic accessory
has been designed to connect specifically to iPod or iPhone, respectively, and
has been certified by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its compliance with
safety and regulatory standards. Please note that the use of this accessory
with iPod, or iPhone may affect wireless performance.
iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of
Apple Inc., registered in the U.S. and other countries.