Basic Operation; Turning On The Power; Using Headphones; Basics Of Playback - Teac CD-RW890 Manual Del Usuario

Basic Operation

Turning on the power

Press the POWER button to turn on the unit.

Using Headphones

For private listening, first reduce the volume level to minimum.
Then insert the plug from your headphones into the PHONES jack,
and adjust the volume by turning the LEVEL knob.
When turning the power on/off, unplug the headphones. Failure to
observe this precaution may cause a noise to be produced.
10

Basics of Playback

1
Press the OPEN/CLOSE (L) button.
The disc tray is opened.
2
Place a disc on the tray with the disc label side up.
<
Never place more than one disc on the tray.
<
The disc must be placed in the center of the disc tray. If the disc is
not correctly loaded, it may not be possible to open the tray again
once it has closed, so you should ensure the disc is always centered
on the tray.
<
Do not force the tray by hand during opening and closing
operations.
3
Press the OPEN/CLOSE (L) button to close the tray.
The tray is closed. Take care that you do not catch your fingers in
the tray.
<
It takes a few seconds for the unit to load the disc. No buttons will
work during loading. Wait until the total number of the tracks and
the total play time of the disc are displayed.